@J SO were you able to get a fresh image installed?
@J SO were you able to get a fresh image installed?
@TX Programmer The Nano is smaller, however it runs REALLY hot. Almost too hot to the touch. The included heat sink really helps though. If you want to encapsulate it inside a device, position it a...
Oh my! This is optimum! Perfect size, keyboard is GREAT. I knead another one of these! 😀 "And when the keyboard backlight flashed on, there was a tiny tear of joy."
After a bit of thought/experience. I don't think a SX1262 needs to be in the Bench Unit. Even low loss LMR cable will cost you 2-3 db in a 30-50 ft length. Maybe the better omni verticals can achie...
@J Glad to be of help. You might take a look at the Bench LoRa post in "Comments". Adding a Nooelec NESDR Mini and a good outdoor vertical would make a "fun" Base Unit with built in Spectrum ...
Thanks! Adding a Nooelec NESDR Mini, a decent antenna, some RG-58 coax. Might make a marketable Spec5 base station?
Found an old, "official" 7" touchscreen I had around. So, I grabbed a 22 to 15 pin DSI display flex cable and cleaned up my bench LoRa "base unit".
@TX Programmer Understood. If you notice, I haven't published any part #s. Because it could undermine your sales. I figure I paid my $399 for my parts list and others are welcome to do the s...
@J My Shift key sometimes "drops out" on the cheap wireless keyboard I use on my media system. I meant 64MB SD Card (actually 8GB would be better since it is quicker to copy/xfer, etc. But size is ...
Never mind, after getting a second device up and running. All is well.
@TX Programmer I'll reply back here once I've got it working...
I finally received my SX1262 from Waveshare and was able to build a Meshtastic image on a 32GB SD card, on an 8GB Pi5 (on my dev workbench). This image is based on the current version (as o...
Ahhhh, That clears things up. I presumed you had it running using the internal Waveshare radio (even with its limited bandwidth). I've got one on order! :-) I presume the Nano 3 - Premium ...
Yup! I saw the writeup on Hackster and jumped right in. I was an early adopter. so mine came with a 4GB Pi. But I have an 8GB Pi I can swap in... BTW folks, NOMAD is very modular and easy to crac...
I HAVE been able to get the Map in the Meshtastic App to update to a "different" position. Although it isn't very accurate at all. I modified the following Meshtastic settings in the Web UI: ----...
Soooo, do you have some settings to get gqrx (shown above) running with the SX1262 card you include with NOMAD? When I open the pre-installed gqrx App in NOMAD, it returns a config error. None of t...
Hello, The SX1262 card doesn't seem to be communicating with the RasPi. When I open the Meshtastic Web App and connect to Device "raspberrypi". The screens "pops up". But it still thinks it is som...
First thing I did upon receiving my NOMAD was setup WiFi and perform sudo apt update & sudo apt upgrade. Which broke several things. :-o One item was xtrx.c. A few kernel API ...