The Strike should charge to full in about 3hrs. Please see the user guide for checking the battery level: https://specfive.com/pages/instructions The Strike carrier board does have a small amount ...

I just got the spec5 strike and it keeps dying. How long does it take to charge. Is this normal 

@James You can find a downloadable User Manual on the product page on the website here:https://specfive.com/products/spec5-trekker-bravo

I just got my Bravo and there is no direction on wht buttons are for or any menue 

Maps need periodic updates. How is this accomplished?   Fred

@John, Under normal use, does the device boot normally? I.e. does the device only boot up with a blank screen when you try to put it in DFU mode? If you're using Windows, when the Ranger Magnu...

Hi Mark,  I would recommend erasing and reinstalling the firmware. Once that's done, I would also recommend changing the bluetooth pin in settings since the default pin is the same across a l...

That's alright. The USA region works between 902-928 MHz. It's usually referred to as 915 MHz as that is the center frequency in the range. 906.875 MHz is the specific default frequency set for the...

>This should make the firmware happy with the region setting. Please let us know if you have any other questions   Make it happy ?    When I do this I still see 907, shouldnt it...

I can't get my device into DFU mode to save my life...  I've tried all the "tricks"... did you struggle in any way to flash it ?    The console log on https://flasher.meshtastic.or...

Received a Nomad2 for Christmas but the box didn't include a charger. I have a barrel plug set but none seem to fit it; does anyone know what barrel type the Nomad2 uses for charging? 

So while it was working I received a message that BDBP-SOLAR02 publicized my public key. Then when I go thome i brought it into the house and then it would not connect via bletooth. I unplugged the...

OK so I purchased your Voyager thru Walmart's website. just powered it up today and after 6 hours i cannot connect to blue tooth?

@Daniel_spec5 It did it again, the bluetotth connection failed after a week in both units I have. I have followed your instructions, thank you very much!  Both devices have been reset and firm...

hi

hi  

I wish they had a power on/off button that could be pressed. The settings are not getting wiped, the device seems to be ok. It's just I can't connect via bluetooth on the meshtastic app. I have to ...

Hi Kevin, I just went through our customer emails and unfortunately I am not seeing an email from you. Sorry that we missed it. Older firmware of the Rak4631 radio module in the Voyager would wipe...

Under the battery door you will find a hole to access the done switch on the back of the keyboard. Press and hold this button with a small screwdriver(or similar) for 5 seconds to put the keyboard ...