You're welcome. That's likely the SX1262 driver breaking - don't have a fix quite yet.

@TX Programmer that's helpful, thanks. do you guys have a fix for the issue Sigmund found with the SDR kmod after a `apt -y dist-upgrade` yet?

Ahhhh, That clears things up. I presumed you had it running using the internal Waveshare radio (even with its limited bandwidth). I've got one on order! :-)   I presume the Nano 3 - Premium ...

The keyboard doesn't have a tab key, but you can easily remap a key of your choice. Here are the steps:   In the terminal, run: sudo apt install input-remapper Once it's installed, run: i...

Re-reading this, it occurs to me you didn't specify which USB SDR dongle you're using. We're using the Nooelec NESDR Mini and that's working just fine. As for settings, start gqrx and then select ...

feel like I must be missing something.

@Sigmund logged into the forum today LITERALLY to ask about exactly this, lololol. also discovered xtrx.c was mad about something. I'm guessing that's part of the SDR hardware in the device. how do...

@Sigmund can you expand on the bit about "building a 64Gb SDRAM from scratch using the Meshtastic guide" and "adding a 1TB NVMe?" is there already support in there for an NVMe drive? and is that gi...

Successful pair of flights with the Georgetown drone today. Thanks to all who said hi!  We saw a lot of new nodes come online. The mesh is growing...

Appreciate your interest in the Nomad, and your diligence in documenting things.  SpecFive is not trying to be a DIY company. We think the biggest service we can provide is in making these de...

Yup! I saw the writeup on Hackster and jumped right in. I was an early adopter. so mine came with a 4GB Pi. But I have an 8GB Pi I can swap in... BTW folks, NOMAD is very modular and easy to crac...

I was in on the 10/27 drone party.  Out-of-town 1028.  Drones are a quick bridge.  I'm liking it.

I HAVE been able to get the Map in the Meshtastic App to update to a "different" position. Although it isn't very accurate at all. I modified the following Meshtastic settings in the Web UI: ----...

Hmm.  Forgot about the hop limit, but would have anticipated the Florence relay would have been visible.  Perhaps the keep-alive ping from that location fell outside drone activity. ...

The drone is an S&F node, yes.  It was flown again for about ~30 mins 5:30pm-6pm CT today (10/28) It is able to bridge quite a large number of nodes. We got a few acks on the public grou...

Sorry about the delay here. Will need a couple of days to set this up again; set it up on a unit that has since been imaged.

Oddly, the 29 and Florence locations can't see each other even with the drone at 400ft AGL. Trying to figure out why that is. With regards to hops, I am not quite certain about your question, but ...

Soooo, do you have some settings to get gqrx (shown above) running with the SX1262 card you include with NOMAD? When I open the pre-installed gqrx App in NOMAD, it returns a config error. None of t...

I cannot see the Florence node either, and I'm on the second floor.  I would need another 240' to hit Spec5. Scadacore indicates no direct line of sight to specfive: 30.8329906, -97.8881598.&n...

I was not trying to discount the importance of a large asset.  One boat could launch a massive drone search for a particular area.  I've had to watch surveillance videos at which point th...