Just got the trekker delta. On the meshtastic software, do I need to set the GPIO settings to anything or just leave blank. I've seen other devices that specify a specific number such as 31. Thanks
Just got the trekker delta. On the meshtastic software, do I need to set the GPIO settings to anything or just leave blank. I've seen other devices that specify a specific number such as 31. Thanks
The Trekker Delta requires no additional settings. We have provided you with everything setup to get you started.
Thank you
I just got the newest trekker. What are the 3 buttons for? I thought the switch on the side was a power on/off switch.
thanks
The Delta has a reset button as well as a "user" button which is used by the Meshtastic firmware to cycle through the screens. The switch on the side is a power switch. This is a full 360' walk through calling out the power switch: https://www.youtube.com/watch?v=8MWnw-_iG0A
